Revit Based (Hydracalc)
Total: 43
Page:
* On smaller devices swipe left to view hidden table data
| Ribbon/Toolbar (Software) | Button | Function | Error Type | Description | ||
|---|---|---|---|---|---|---|
| Ribbon/Toolbar (Software) | Button | Function | Error Type | Description | ||
| View (card-1286) | HydraCALC (Revit Based) | Define Supply | None | Command Failure For External Command | Command Failure for External Command... The Parameter is Read-Only
|
|
| View (card-1213) | HydraCALC (Revit Based) | Hydraulic Calculations | Return To Revit | None | No error, but after returning to Revit, no demand info block turns up. |
|
| View (card-1195) | HydraCALC (Revit Based) | Supply Point | None | None | No error, but the section's background becomes blue / light blue after placing down the supply point
|
|
| View (card-1190) | HydraCALC (Revit Based) | Hydraulic Calculations | None | None | Unhandled Exception - System.FormatException: Input string was not in a correct format
|
|
| View (card-1168) | HydraCALC (Revit Based) | Hydraulic Calculations | Continue | None |
|
|
| View (card-1150) | HydraCALC (Revit Based) | Hydraulic Calculations | None | None | Autodesk.Revit.Exceptions.FileNotFoundException: C:\HES\Hydratec for Revit\DATA\Families\2022\Annotation\Hydraulic Referece Point - HydraCAD.rfa
|
|
| View (card-1149) | HydraCALC (Revit Based) | Define Supply | None | Command Failure For External Command | Revit could not complete the external command... Autodesk.Revit.Exceptions.InvalidOperationException
|
|
| View (card-1117) | HydraCALC (Revit Based) | Hydraulic Calculations | None | None | When trying to run a calc for the system, this error appears:
|
|
| View (card-1111) | HydraCALC (Revit Based) | Hydraulic Calculations | Load Defaults | None | Unable to load defaults during HydraCALC Setup. Occasionally will give an error, but most commonly nothing will be filled in.
|
|
| View (card-1109) | HydraCALC (Revit Based) | Supply Point | None | Command Failure For External Command | Revit could not complete the external command... No work plane set in current view
|
|
Page:
